Hi, I am trying to install the ilbc codec. I downloaded the asterisk and ilbc source and then configured and compiled the code in a separate directory. I then copied over the codecilbc.so. However, when I tried to load the module, I get this error:2011-06-18 00:54:32 WARNING1479: loader.c:768 inspectmodule: Module ‘codecilbc.so’ was not compiled with the same compile-time options as this version of Asterisk.2011-06-18 00:54:32 WARNING1479: loader.c:769 inspectmodule: Module ‘codecilbc.so’ will not be initialized as it may cause instability.2011-06-18 00:54:32 WARNING1479: loader.c:852 loadresource: Module ‘codecilbc.so’ could not be loaded.Where can I download a copy of the codecilbc.so for 2.9? Or how do I compile one that works?
Hi AllI am new to Asterisk,I am using CentOS 5.9 final version at server and client end, I am sending voip traffic from asterisk 1.8 server through openvpn to asterisk '1.8' clients.These codecs are installed ' g723 gsm ulaw alaw g726aal2 adpcm slin lpc10 g729 speex ilbc g726 g722 siren7 siren14 slin16 g719 speex16 testlaw'.There are GOIP 16 ports GSM gateways with asterisk client pcWhen I send traffic from server to clients it works fine with 5 calls but when I increase the number of calls, call fails. Not (sensibly) possible, to change the table.I doubt that 8kbps per channel is possible except with special compression and multiplexing techniques, as the overhead for simple RTP with standard packetisation intervals is larger than that. I would start by eliminating all the codecs that require more than 6kpbs, for the raw media, from the allow list. I'm not sure if Asterisk actually has any such codecs. Then you will have to solve the problem of mulltiplexing them efficiently.IAX may be better than SIP.I believe there is third part software, but that is generally only used in low wage countries.For anyone else reading this, whilst the codec translation paths table is about CPU usage, I think the resource limit here is network bandwidth.
Install Ilbc Codec Asterisk Server Windows 10
The first line for controlling that is the allow rules, but that isn't going to be enough. Moves Like Spencer Posts: 12570 Joined: Fri Sep 26, 2008 5:03 am. Dear DavidYes you are right, I wanna use it for low bandwidth, I wanna run 64 channels on 512Kbps. HiI have one Asterisk server with a big pipe of bandwidth, this server can support up to 120 simultaneous calls, so I send the traffic from server to various asterisk client PC each client pc 'P4 1.8GHz processor, 2GB RAM' can support up to 64 calls with 1024Kbps upstream and 4088Kbps down stream DSL. I am already running this solution, I have configured asterisk Server and asterisk client pcs, the only thing which is being problem for me is the number of calls.When I use my own configured server it support only five calls, if I use the server which is configured by a professional it supports 64 calls on one DSL. Thing I wanna know is how can I change the codec rate.The only difference in these two server is codec rate, how and from where I can change it.regards Newsterisk Posts: 3 Joined: Tue May 28, 2013 11:23 am.
